4.2.3. Carefully drill the holes using a high-speed, electric drill.
•
Don’t drill too far at once (say more than 20mm) because this can
'over-bore' the hole. Make sure the hole is about 20 mm deeper than
the longest probe.
•
Remove the jig and 'plug’ the holes with Vaseline.
•
Take a 'cork bore' around the two outer holes so you can measure
the bark depth, D (mm),
e.g.
with a set of calipers.
insert:
•
Dip each probe in Vaseline, and then insert it CAREFULLY into
the appropriate hole. The probe marked with the red dot goes
closest to the heater. Insert the heater last.
•
Tape the probes CAREFULLY to the tree stem, but don’t bend
them to far!!
•
Check each probe to make sure its OK (see 4.1)
IF its OK THEN
•
connect it to the logger.
ELSE
•
get some new probes
•
goto insert
ENDIF
4.3. Testing if everything is working.
Make sure the HPV system is properly connected (see 3.2 above)
Make sure the logger is properly programmed (see 5 below)
Fire a test pulse (see 5 below)
IF it seems to be OK THEN
go for a beer
Comments to this Manuals