Campbell CS225 Instruction Manual download pdf (Page 23)

CS225 Temperature String

Figure 7—2 Screen capture of SDI-12 Transparent Mode on

CRBasic CR800 Datalogger using control port 1 and prompting for

SDI-12 addresses

6. To change the SDI-12 address, press the <enter> key. At the “CR800>”

”CR1000>” prompt enter the command SDI-12 and press the <enter> key.

Enter the appropriate control port, press the <enter> key, and enter aAb!;

where a is the current address from the above step and b is the new

address. The temperature sensor will change its address and the datalogger

will respond with the new address and then exit the SDI-12 Transparent

Mode.

1 2 ... 18 19 20 21 22 23 24 25

No comments

Campbell CS225 Instruction Manual Page 23