CURS100 100 Ohm Current Shunt Terminal Input Module Issued: 17.9.13 Copyright © 2000-2013 Campbell Scie
CURS100 100 Ohm Current Shunt Terminal Input Module 2 Figure 2-1. CURS100 schematic The CURS100 has three pins: high, low, and ground; these pins
User Manual 3 3.1 Differential Measurement The voltage across the completion resistor is measured with the differential voltage measurement. Use Vol
CURS100 100 Ohm Current Shunt Terminal Input Module 4 Figure 3-1. CURS100 L terminal connected to a datalogger G terminal using a jumper wire. Norm
User Manual 5 Figure 4-2. 2-wire with external power 4.1.1 Possible Ground Loop Problems The resistor must be grounded at the datalogger to ensure
CURS100 100 Ohm Current Shunt Terminal Input Module 6 4.2 Three-Wire Transducers A three-wire current loop transducer has the power supply connected
User Manual 7 Figure 4-7. 4-wire with external power 5. Sensor and Programming Example In this example, the input voltage range, and the multiplier
CURS100 100 Ohm Current Shunt Terminal Input Module 8 The transducer will output 4 mA at 200 psi and 20 mA at 700 psi. Using Ohm's law, the vol
User Manual 9 Public Measure DataTable (Hourly,True,-1) DataInterval (0,60,Min,0) Average (1,Measure,IEEE4,0) EndTable BeginProg Scan (1,Sec,1,0
CAMPBELL SCIENTIFIC COMPANIES Campbell Scientific, Inc. (CSI) 815 West 1800 North Logan, Utah 84321 UNITED STATES www.campbellsci.com • info@campbel
Guarantee This equipment is guaranteed against defects in materials and workmanship. This guarantee applies for twelve months from date of delivery.
PLEASE READ FIRST About this manual Please note that this manual was originally produced by Campbell Scientific Inc. primarily for the North American
Contents PDF viewers: These page numbers refer to the printed version of this document. Use the PDF reader bookmarks tab for links to specific secti
1 CURS100 100 Ohm Current Shunt Terminal Input Module 1. Introduction Terminal input modules connect directly to the datalogger's input termin
Comments to this Manuals