Campbell Redwing 105 Instruction Manual download pdf (Page 15)

Raven X-HSPA Sierra Wireless Cellular Modem

x Signal – Light shows the strength of the signal and may be nearly solid

(strong signal) or flashing (weaker signal). A slow flash indicates a very

weak signal.

x Activity – Lights will flash as data is transferred to and from the modem

on the network.

x Service - Indicates when the connection is HSUPA/HSDPA or UMTS.

Unlit indicates EDGE or GPRS.

x Power – Indicates the power adapter is connected and there is power

getting to the Raven X.

x The Reset button (on the left side of the Raven X) has two functions. If it

is quickly depressed and released, the modem will simply power cycle the

internal hardware. If, however, the reset is depressed and held for several

seconds (count 10 slowly, and wait for the power light to go off after the

light pattern stops), the ALEOS configuration settings will return to the

factory defaults.

Light Patterns

The LEDs on the front of the modem will respond in different patterns to

indicate modem states.

x Normal – Each LED, mentioned above, lit as applicable.

x Start up – The LEDs will cycle from left to right.

x PassThru mode – Network and Signal LEDs will blink in tandem. The

Activity LED will blink when transmitting or receiving data.

x SOS – The Network LED blinks.

x Configuration Reset – The LEDs will cycle left to right and then right to

left 4 times.

x Authentication Failure – The Network, Signal, and Activity LEDs blink

every 2 seconds.

x Data Retry – The Network, Signal, and Activity LEDs blink every 3

seconds.

x Invalid MAC Address or Ethernet Initiation Fail - The Service LED

will blink.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

No comments

Campbell Redwing 105 Instruction Manual Page 15