Campbell Redwing 105 Instruction Manual download pdf (Page 8)

Raven X-HSPA Sierra Wireless Cellular Modem

4 Configuration

4.1 Base Station Requirements for Raven X-HSPA

A PC running Campbell Scientifics’ LoggerNet or PC400 software, with access

to the Internet.

4.2 Datalogger Site Equipment

x Raven modem with power cable (included with modem).

x Antenna - The antenna chosen for use in your application must be

connected to the “Antenna” connector of the RAVEN X modem. Do not

connect the antenna to the Rx Diversity connector.

x Datalogger – CR1000, CR3000, CR800 series, CR200 series, CR510,

CR10(X), CR23X, CR5000.

x SC105 or SC932A Interface – connects the modem to the CR510,

CR10(X) or other dataloggers’ CS I/O port.

x The SC105 must be configured for use with the modem using the Device

Configuration Utility. Settings should be:

CS I/O Mode: SDC Address 7

RS-232 Mode: Modem

Baud Rate: 115.2K or 9600 baud depending on datalogger model

8 data bits, 1 stop bit, no parity

x L18663 Null Modem Cable – connects the modem to the CR1000,

CR3000, CR800 series, CR200 series, CR23X, or CR5000 RS-232 port.

x L13658 Ethernet Cable – connect the modem Ethernet port to a PC or

other Ethernet device. The Raven X Ethernet port is auto-sensing so a

cross-over cable can also be used.

x C2675 RAVEN Mount Kit – Used to mount the modem in the datalogger

enclosure with the use of DIN rail and DIN rail adaptors.

If you have a black SC12 cable that is not Rev 1 or newer (as indicated on

cable), it is a CS I/O cable only and will not work for RS-232. Connect the

black SC12 cable between the datalogger and the SC932A. Use a 9-pin serial

cable or a blue ribbon cable between the phone and the SC932A.

NOTE

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 35 36

No comments

Campbell Redwing 105 Instruction Manual Page 8